Safety Consulting Services (SCS) provides training, program development, program review, audits/inspections and general consulting services in the areas of Safety, Environment, Security, and Emergency Management. Each SCS consultant has over 25 years of experience.
A Preventable Electrical Accident Happens Every 23 Minutes
Products and Services
Electrical Safety Training
Environmental Safety Training
General Training
Consulting Services
Other Home Pages
For More Information Contact Mr. Leo Muckerheide
Phone/Fax:(512) 868-5838
Safety Consulting Services
Safety Consulting Services
![]()
Electrical Safety Training
All Employees
Supervisors/Managers
Unqualified Personnel
Qualified Personnel
A one hour seminar for all personnel that provides basic awareness
of the Hazards of Electricity. Everyone today uses electrical devices of
some kind. Therefore they should be aware of the hazards.
A two hour seminar for busy supervisors that provides basic review/orientation
to the Hazards of Electricity and Electrical Safety Related Work Practices.
A four hour seminar for all personnel that work around, but not on, electrical
equipment or circuits. Provides these "unqualified persons" a
understanding of the hazards of electricity, safe use of electrical equipment,
and protective equipment.
1 - An eight hour seminar for personnel who work on or near what OSHA identifies
as utilization/production power. Typical this consists of circuits and
equipment operating at voltages from 120 to 600volts. However, there are
higher voltages used for utilization/production power.
2 - An eight hour seminar for personnel who work on generation, transmission,
or distribution power. Addresses topics such as hazards of electricity,
job briefing, hazardous energy control, electrical protective equipment,
working on or near exposed energized circuits, minimum approach distances,
grounding, etc.
3 - A sixteen hour seminar for personnel who work on both utilization/production
and generation, transmission, or distribution power. Covers subjects like
hazards of electricity, training requirements, work on de-energized &
energized equipment, use of electrical equipment, electrical protective
equipment, de-energizing lines and equipment, etc.
1 - Hazardous Waste Generator Awareness - 40CFR262 &265
2 - Hazardous Waste Operations - 29CFR1910.120
3 - Hazardous Communication - 29CFR1910.1200
4 - Spill Prevention, Control, and Countermeasures - 40CFR112
5 - Hazards Materials Shipping - 49CFR172 & 173
6 - Respiratory Protection - 29CFR1910.134
7 - Asbestos - General Industry - 29CFR1910.1001
1 - Control of Hazardous Energy (Lockout/Tagout)
2 - Permit Required Confined Space
3 - Fall Protection
4 - Federal Employees Occupational Safety & Health
1 -
Arc Hazard Risk Analysis (Click Here)
2 - General Safety Consulting
3 - Safety Program Reveiw, Analysis, and Development
4 - Compliance Auditing, Pre-OSHA Inspections
5 - Craft Specific Safety Consulting
6 - Protective Equipment and Apparel Use and Certification
7 - Managing for an Improved Safety Record.
8 - Client Specified Safety Consulting
Are your employees adequately protected from the hazards of arc and flame?
Is your company vulnerable to an OSHA citation for not meeting apparel
standards?
If your answer is yes to either or both of these questions,
Safety Consulting Services can help you. For less than the cost of the
minimum OSHA fine, Safety Consulting Services will conduct an "Arc Hazard
Risk Analysis" for your facility. This analysis will provide the necessary
information to determine the need for any special clothing to protect your
workers from the hazards of an arc. Special clothing is expensive and an
Arc Hazard Risk Analysis would identify the level of protection required.
Your company could save a significant amount of money by not purchasing
unneeded special clothing.